Fracture behavior of a thermoplastic polyolefin (TPO) under airbag deployment conditions evaluated through Reversed Charpy tests

For the past decades, polymers such as polypropylene (PP) and polyvinyl chloride have replaced metals as the main material for automotive instrument panel construction. However, their high sensitivity to temperature and strain rate can result in malfunctioning of airbag systems, so thermoplastic polyolefins (TPOs) have gained popularity for instrument panels as they are less sensitive to temperature. Nonetheless, the relationship between the fracture behavior of TPOs and the typical airbag deployment conditions have not been thoroughly discussed yet. Therefore, this study will investigate the fracture behavior of an automotive TPO material under plane stress conditions via Reversed Charpy tests, emulating the fracture process of the instrument panel tear line at different temperatures and strain rates. Experimental results showed that the yield stress and plastic work dissipation, w p , are higher at low temperatures, with a distinguishable transition (drop) around the glass transition temperature of the PP matrix. Additionally, w p increased at low temperatures when increasing the impact speed suggesting that the deformation process changes from isothermal to adiabatic, increasing the temperature at the crack tip. This was supported with the fracture surface analysis, in which a relaxation zone near the crack tip caused by a temperature increase was observed. Additionally, quasi-static tensile, tear and single-edge notch bending (SENB) tests were performed. Yield stresses obtained with Reversed Charpy were lower than those obtained with tensile tests, due to the higher shear stresses and plastic deformation promoted by plane stress conditions during Reversed Charpy tests, highlighting the importance not only of temperature and strain rate, but also of the geometry of the specimen, when characterizing materials for instrument panel construction. This works shows how the Reversed Charpy test can characterize the fracture of instrument panel materials, leading to cheaper evaluation of new materials and safer airbag deployment in an accident. • The dynamic fracture behavior of a TPO was evaluated through Reversed Charpy tests. • Reversed Charpy test can characterize the fracture of instrument panel materials. • Lower yield stresses were found with Reversed Charpy rather than with tensile tests. • Plastic work dissipation increased at low temperatures when increasing impact speed. • At high impact speeds the deformation process changes from isothermal to adiabatic.