In situ static elastic properties assessment and validation with pressuremeter testing using a formation tester tool

Pressuremeter testing (PMT) is a formation test that consists of inflating a cylindrical packer inside a borehole while measuring the radial deformation or injected fluid volume as a function of packer pressure. Provided that the stiffness of the packer measuring system is known and large enough compared to that of the formation, changes in packer pressure associated with changes in injected fluid volume provide a direct measurement of formation stiffness. In turn, the in situ static shear modulus is obtained from the formation stiffness at a length scale similar to that of the packer. Here, we report on the first field-scale campaign of PMTs in deep boreholes performed using a wireline formation tester (WFT) tool. We carried out PMT measurements as part of the characterization and appraisal of potential sites for a deep geological repository for radioactive waste in Switzerland. We performed multiple PMT inflation cycles to infer in situ static shear moduli at six stations spread across four boreholes. PMT-derived static shear moduli results were consistent with static shear moduli derived from sonic logs using independent dynamic-to-static elastic moduli transformations. PMT-derived static shear moduli and laboratory-derived static elastic moduli using samples from coring performed at the depths of the PMT stations were consistent, with slightly lower laboratory values. Furthermore, we report dynamic-to-static shear moduli transformations by using laboratory-scale data obtained on cores and field-scale derived from sonic logs and PMT. We observed differences between static and dynamic shear moduli derived from laboratory scale using cores and field scale using sonic logs and PMT. We report linear trend slopes of about 0.5 for the laboratory data and 0.7 for the field data. These first results show the viability of in situ PMT in deep boreholes with a WFT tool, as it can be performed at multiple depths in a single run, in a time-efficient manner, and in combination with micro-hydraulic and sleeve fracturing stress tests for an integral approach to in situ geomechanical assessment. • PMT with a wireline formation tester done at exceptional depths (400–1000 m). • Interpretation framework and a detailed error analysis are provided. • Field tests are consistent with empirical dynamic-to-static elastic transformations. • Lab tests on cores from the same interval support the PMT field tests robustness.