Online Calibration of Inertial Sensors Based on Error Backpropagation

Global satellite navigation systems (GNSSs) are the most-used technology for the localization of vehicles in the outdoor environment, but in the case of a densely built-up area or during passage through a tunnel, the satellite signal is not available or has poor quality. Inertial navigation systems (INSs) allow localization dead reckoning, but they have an integration error that grows over time. Inexpensive inertial measurement units (IMUs) are subject to thermal-dependent error and must be calibrated almost continuously. This article proposes a novel method of online (continuous) calibration of inertial sensors with the aid of the data from the GNSS receiver during the vehicle's route. We performed data fusion using an extended Kalman filter (EKF) and calibrated the input sensors through error backpropagation. The algorithm thus calibrates the INS sensors while the GNSS receiver signal is good, and after a GNSS failure, for example in tunnels, the position is predicted only by low-cost inertial sensors. Such an approach significantly improved the localization precision in comparison with offline calibrated inertial localization with the same sensors.