Enhanced Electrocaloric Effect of PVDF-based Polymer Composite with Surface Modified AlN

Poly(vinylidenefluoride-trifluoroethylene-chlorotrifluoroethylene) (P(VDF-TrFE-CTFE)) relaxor ferroelectric polymer exhibits a modest electrocaloric effect (ECE) at a low electric field near room temperature and a low thermal conductivity. The low thermal conductivity causes poor heat transfer when the terpolymer is used as a cooling device, even when the ECE of the polymer is substantial. By incorporating aluminum nitride (AlN) nanoparticles, which possess high thermal conductivity and good electrical insulation properties, into polymer matrices, we can enhance both the thermal conductivity and the ECE. However, weak bonding at the AlN-polymer interface can lead to a reduced breakdown electric field. Therefore, surface modification of AlN nanoparticles is performed to strengthen the chemical bonding between AlN and the terpolymer, thereby increasing the breakdown electric field. Following the addition of surface-modified nanoparticles, the breakdown electric field of the composite films remained around 240 MV/m, which is comparable to that of the pristine polymer film. Furthermore, the ECE and thermal conductivity were improved by 44% and 55%, respectively. We found three factors influencing the ECE, including the interface effect, the change in ferroelectric-paraelectric phase transition behavior, and the Joule heating effect. To assess the interfacial effect on the ECE, composite films with AlN particles of four different sizes were prepared. It was found that as the size of the nanoparticles increased, which resulted in a decreased interface area, the ECE decreased correspondingly. This finding further confirms the significant impact of the interface area in the composites on the ECE.