Advanced, Real-Time Programmable FPGA-Based Digital Filtering Unit for IR Detection Modules

This paper presents a programmable digital filtering unit dedicated to operating with signals from infrared (IR) detection modules. The designed device is quite useful for increasing the signal-to-noise ratio due to the reduction in noise and interference from detector–amplifier circuits or external radiation sources. Moreover, the developed device is flexible due to the possibility of programming the desired filter types and their responses. In the circuit, an advanced field-programmable gate array FPGA chip was used to ensure an adequate number of resources that are necessary to implement an effective filtration process. The proposed circuity was assisted by a 32-bit microcontroller to perform controlling functions and could operate at frequency sampling of up to 40 MSa/s with 16-bit resolution. In addition, in our application, the sampling frequency decimation enabled obtaining relatively narrow passband characteristics also in the low frequency range. The filtered signal was available in real time at the digital-to-analog converter output. In the paper, we showed results of simulations and real measurements of filters implementation in the FPGA device. Moreover, we also presented a practical application of the proposed circuit in cooperation with an InAsSb mid-IR detector module, where its self-noise was effectively reduced. The presented device can be regarded as an attractive alternative to the lock-in technique, artificial intelligence algorithms, or wavelet transform in applications where their use is impossible or problematic. Comparing the presented device with the previous proposal, a higher signal-to-noise ratio improvement and wider bandwidth of operation were obtained.