Rollover prevention by designing a new fuzzy set solution for automotive active stabilizer bars based on a complex dynamic model

In this paper, the author introduces using active stabilizer bars (hydraulic anti-roll bars) for automobiles to improve the stability of rolling over when an automobile is steering. The car rollover oscillation is described by a complex dynamic model, a combination of the Pacejka tire model, the motion model, and the full oscillation model. A new fuzzy solution has been developed in order to control the active stability bars. This algorithm has three inputs related to the car’s rollover factor. The fuzzy rule (with 125 situations) and membership function are determined based on views related to the car’s stability and the antiroll system’s responsiveness. Numerical calculations and simulation are performed with two cases corresponding to two kinds of steering angles. Three situations correspond to three velocity values: v 1 , v 2 , and v 3 , and four scenarios are simulated in each situation to facilitate the comparison of results. According to the research findings, output values such as roll angle, rollover index, and load change are drastically reduced when the new fuzzy solution is applied to the active anti-roll bars. In the last case, the rollover occurs when the automobile does not use any stability bars or uses regular mechanical bars. The roll angle peak values reach 8.79° and 10.79°, while the maximum value belonging to the Active with Fuzzy situation is 10.94° without rolling over (corresponding to a rollover index of 0.64). The results obtained from this paper are the basis for developing more complex solutions for stabilizer bars in the future.