Optimization of Welding Process for 825 Bimetallic Composite Pipes Based on Corrosion Testing

Abstract In the process of welding bimetallic composite pipe ring joints, a problem arises where the outer layer of carbon steel dilutes the inner corrosion-resistant alloy lining, resulting in a reduction in corrosion resistance. Therefore, selecting the appropriate welding process and parameters is crucial. This study established manual, semi-automatic, and fully automatic welding processes for welding 825 bimetallic composite pipes, conducted simulated corrosion tests on weld joint ring seams under sulfur-containing conditions, and performed comprehensive evaluations of physical and chemical properties, as well as corrosion resistance. The research findings are as follows: (1) There is a phenomenon of softening in the heat-affected zone of bimetallic composite pipe ring seams. Among them, the fully automatic welding method exhibits significant fluctuations in weld joint strength, higher toughness in the weld and heat-affected zone, and higher hardness values with less variation compared to other welding methods. (2) Under the manual, semi-automatic, and automatic welding processes, the intergranular corrosion rates are 1.08 mm/a, 1.64 mm/a, and 1.11 mm/a, respectively, and the pitting corrosion rates are 0.41 g/m 2 , 0.25 g/m 2 , and 0.31 g/m 2 , respectively. The uniform corrosion rates are 0.0002305 mm/a, 0.0002183 mm/a, and 0.0002197 mm/a, respectively. (3) High-temperature solution heat treatment (above 980 ° C for 30 minutes) can effectively promote the dissolution of carbides into the matrix, improving the intergranular corrosion resistance of alloy 825. The research demonstrates that under sulfur-containing conditions, weld joints obtained using the fully automatic welding process developed in this study exhibit better physical characteristics and corrosion resistance. This can effectively prevent corrosion failures and leakage incidents.