Bond of <scp>FRP</scp> bars in fine‐grained alkali‐activated concrete

Abstract Alkali‐activated cement (AAC) is an alternative binder with a promising potential to replace ordinary Portland cement (OPC) and mitigate its environmental issues. The use of fiber‐reinforced polymer (FRP) reinforcements with AAC concrete enables the development of corrosion‐resistant, environmentally friendly reinforced concrete structures. Bond behavior is critical in reinforced concrete structures and must be thoroughly studied for such new alternative materials. This study employs pullout tests to investigate the bond behavior between FRP bars and fine‐grained AAC concrete. Three fine‐grained AAC concretes with low to high strength, glass and carbon FRP bars and wrapped, milled, and smooth surface treatments were examined. The effect of bar casting position was also investigated. The compressive strength showed a significant influence on the bond strength. An average bond strength of approximately 18 MPa was observed for both glass and carbon FRP bars when used with 65 MPa concrete. Both the glass and carbon FRP bars with wrapping showed a lower bond strength than their milled FRP bars counterparts. The carbon bars without surface preparation (smooth bars) resulted in a much lower bond strength, around 4 MPa. In terms of casting positions, the bars cast in the middle section of the concrete block showed a higher bond strength than those at the bottom and top.