THE EFFECT OF HEAT-TREATMENT ON THE MECHANICAL PROPERTIES OF EXPANDED GLASS PARTICLE/A356 SYNTACTIC FOAM

This research investigates the manufacturing of metal syntactic foams (MSFs) using a packed bed of porous (2-2.8 mm) expanded glass (EG) within an A356 alloy matrix. To this end, the counter-gravity infiltration casting technique is employed to manufacture the specimens. The density of the MSFs ranges from 1.05 to 1.17 g/cm3, making it one of the lowest densities foams, attributed to the filler particles' low bulk density. The study investigates the influence of T6 heat treatment on the mechanical properties and microstructural characteristics of the manufactured MSFs. The mechanical properties of the MSFs are characterized under quasi-static compressive loads at 1 mm/min. After heat treatment, the compression test results indicate a significant enhancement in most mechanical properties. Compression strength and plateau stress are approximately doubled compared to as-cast foams for samples with similar densities. While energy absorption of the MSFs triples in heat-treated conditions. These improvements are attributed to changes in the matrix microstructure due to thermal treatment. Microstructural analysis reveals that Si particles, initially sharp and continuous within inter-dendritic boundaries, become blurry and discontinuous through spheroidization after thermal treatment. This hinders crack growth in the cell wall and mitigates the effects of casting defects and the columnar dendritic structure. The majority of mechanical properties in both heat-treated (HT) and as-cast (AC) foams exhibited an increase in density due to an increase in the matrix fraction. However, plateau end strain and energy absorption efficiency demonstrated an independent effect of heat treatment and density.