Micromechanics Modeling on Mechanical Properties in Mg Alloys with Bimodal Grain Size Distribution

Bimodal grain structure (BGS) Mg alloys containing a high fraction of fine grains (FGs) and a low fraction of coarse grains (CGs) show a good combination of strength and plasticity. Here, taking the ZK60 alloy as an example, the influences of CG size, volume fraction, and texture intensity on mechanical properties and the hetero-deformation-induced (HDI) effect were examined using the Mori-Tanaka mean-field method combined with strain gradient theory of plasticity. The results indicate that the overall mechanical properties decrease with an increase in CG size because the limited HDI effect cannot compensate for the strength and plasticity decrease derived from larger CGs. A higher aspect ratio of CG along the loading direction can weaken the HDI effect and subsequently reduce the overall mechanical properties. Optimal comprehensive mechanical properties can be achieved when the CG volume fraction is approximately 30%. Furthermore, an increasing basal texture intensity in CG results in higher yield strength and lower ultimate tensile strength, while the uniform elongation reaches a maximum value when ~60% of CGs possess hard orientations with Euler angles of (0~30°, 0°, 0°).