The chlorination and separation of aluminum using low-temperature sulfur chloride reagents

There is currently no strategy for the permanent waste disposal or recycling for used nuclear fuelsfrom research reactors. For this reason, low-temperature reactions have been developed for thechlorination of the Al alloys and subsequent separation from used nuclear fuels to reducethe volume of high-level waste in storage. Three sulfur chloride reagents – S₂Cl₂, SOCl₂, and SO₂Cl₂—were tested, and two were found to quantitatively chlorinate Al metal and Al alloys undermild conditions. Further, these low-temperature reactions proceed between 298 and 411 K, and up to 5 gof metal is chlorinated in 1–3 h. Preliminary results indicate that the reactivity and exothermicity ofthe reaction between the Al and sulfur chloride reagents is highly dependent on the surface area-to-volume ratio of the metal and the volume of solvent. Elemental S is produced as a by-productduring the chlorination with S₂Cl₂ but can be quantitatively rechlorinated under mild conditions toregenerate the initial chlorination reagent. Therefore, in this case, chlorine is the only elementconsumed in the reaction, thus minimizing the waste generated during the chlorination process.The AlCl₃ may then be separated from other materials present in Al 6061 or Al 8001 because of itshigh solubility in the sulfur chloride reagents. This process may also be extended to chlorinate Alfrom research reactor fuels.