Hot Deformation Behavior and Microstructure Evolution of the Maraging Stainless Steel

Hot deformation behavior of the maraging stainless steel is studied in temperature range from 900 to 1150 °C and strain rate from 0.1 to 10 s −1 . When the deformation temperature is 900−950 °C, the abnormal stress increase is observed at the end of the flow curves. Transmission electron micrographs reveal that the Laves phase at the interface between prior austenitic ( γ ) and high‐temperature ferrite ( δ ) impedes hot deformation. The microstructure analysis shows that the dynamic recrystallization (DRX) mechanism of γ and δ is discontinuous DRX and continuous DRX, respectively. When the specimens are deformed at 950 °C, the extent of DRX at a strain rate of 5 s −1 is higher than at 0.1 s −1 . This anomaly is due to adiabatic heating causing the actual deformation temperature at high strain rate () to be higher than at low , indicating that DRX is more influenced by temperature compared to . The influences of adiabatic heating and friction are corrected. Strain‐dependent constitutive equation is developed based on the revised flow curves, yielding an average absolute relative error of 4.69% and a correlation coefficient of 0.99; the prediction accuracy exceeds 90% when the relative error is within 10%.