The influence of V microalloying on the hot deformation behavior and microstructure evolution of high-manganese steel for LNG storage tanks

Herein, the high-temperature hot deformation and dynamic recrystallization (DRX) behavior of high-manganese steel were investigated through the measurement of true stress-strain curves, the establishment of constitutive equations, the construction of recrystallization and hot processing maps, and the characterization of microstructure evolution. Furthermore, the influence of V on the DRX behavior of high-manganese steel during the hot deformation process, particularly for LNG storage tanks, was systematically evaluated. The results indicate that both the critical stress ( σ c ) and peak stress ( σ p ) of the tested steels increase as the deformation temperature decreases and the strain rate increases. Additionally, a higher V content leads to an increase in σc and σp, thereby suppressing the occurrence of DRX. Compared to 0.1V steel, 0.2V steel precipitates a greater quantity of carbides at the grain boundaries (GBs), which effectively stabilizes the GBs and inhibits the growth of DRX grains. In contrast, 0.1V steel achieves DRX over a wider range of Z parameters (at lower temperatures and higher strain rates). The activation energies for hot deformation ( Q ) of the two tested steels are 479.100 kJ/mol and 438.274 kJ/mol, respectively. The hot processing maps indicate that an increase in V content reduces the hot workability of high-manganese steel. The optimal temperature and strain rate for hot processing of 0.1V steel are 1035–1095°C and 0.01–0.0451 s⁻ 1 , respectively. For 0.2V steel, the optimal hot processing parameters are a temperature of 1065–1100°C and a strain rate of 0.01–0.07 s⁻ 1 .