Experimental Study of Wave Load Distributions on Pile Groups Affected by Cap Structures and Pile Spacings Under Varied Wave Conditions

Wave-induced forces pose significant challenges to marine structures, especially pile groups, where cap structures and pile spacings play critical roles in load distribution and structural stability. A physical wave flume experiment was conducted to investigate the influences of cap structures and pile spacings on wave load distributions under different wave conditions. Spatial and temporal variations in wave load distributions, including temporal variations in horizontal force, were measured as wave pressure rather than force. The results demonstrate that cap structures significantly alter the distributions of wave loads on pile groups. The integration of the cap increases the horizontal forces on the front pile and slightly reduces the vertical pressures across the pile group, particularly on the rear pile at relatively low elevations. The cap also delays the peak moment of horizontal force, especially in shallow water depths, where impact loads are more prominent and the cap induces water splash-back. Additionally, reducing pile spacing mitigates interference effects, optimizing the load distribution across piles by modulating flow velocity and pressure. The vertical pressure distribution exhibits a tiered pattern, with lower sections experiencing consistent loading, middle sections being subjected to higher loads at larger spacings, and upper sections being more affected by the cap at smaller spacings. As wave velocity and water depth increase, the differences in pressure intensity between pile groups with and without cap structures decrease, indicating the stabilizing effect of wave characteristics on structural response. This study provides insights into the design of marine pile group structures to optimize their performance characteristics under dynamic wave loading conditions.