Effect of Solution Aging Heat Treatment on Tribological Properties of Selective Laser Melted WC/18Ni300 Composite

Different contents of WC particle‐reinforced 18Ni300 composites are prepared by selective laser melting method, and the tribological properties are comparatively studied before and after solution aging heat treatment. The results show that a part of WC particles are dissolved, and no obvious pore defects appear. With the increase of WC content, the microstructure gradually transforms from cellular and fine columnar α‐Fe martensite to γ‐Fe austenite. After solution aging heat treatment, the phase is transformed into acicular martensite. The grain size significantly decreases, and the Vickers hardness increases. The grain size decreases and the hardness increases with increasing WC contents. For the as‐built composite, the friction coefficient first decreases and then increases, and the wear rate first increases and then decreases with the increase of WC content. With WC content increasing, the wear rate first decreases and then increases. After heat treatment, the tribological properties are improved. The groove of the specimens before heat treatment is deep with large delaminated craters, and the wear mechanism is dominated by adhesive and abrasive wear. The grooves become shallower, and the adhesive trace becomes lighter after heat treatment. The wear mechanism is mainly adhesive wear and abrasive wear, accompanying with oxidative wear.