Study on Shutter Heating Performance of Gas Turbine Intake System

Abstract Aiming at the anti-icing and de-icing requirements of gas turbine intake system, study the heating performance of a typical shutter vane, and compares and analyzes the influence of different ambient temperature and different electrothermal pipe heat generation rate on vane temperature distribution and heat transfer characteristics. The results show that the air convection at different positions on the blade surface of the louver leads to the difference in the temperature distribution of the upper and lower surfaces of the blade, as well as the leading edge and trailing edge of the blade, and the leading edge of the blade, as the area with the lowest overall temperature distribution of the blade, should be focused on in the design of anti-icing and de-icing systems. Increasing the heat production rate of the electric heating tube, there is more heat flow near the midline of the blade, which makes the temperature rise at this position the highest, and it is necessary to pay attention to the energy waste and blade damage caused by local overheating of the blade. Therefore, when the ambient temperature increases from 245.15 K to 318.15 K, the leaf temperature increases from 248.73 K to 322.74 K, and the temperature rise also increases from 3.58 K to 4.59 K. The electrothermal technology can be used to the anti-icing and de-icing of the intake system shutters on the basis of choosing the heat generation rate of the electrothermal tube reasonably.