Effect of Rolling Process Parameters on Transverse Cracks on the Surface of Q345 Steel

This article examines the evolutionary behavior of transverse surface cracks in Q345 steel during the hot‐rolling process under various rolling conditions. “V”‐shaped cracks are prefabricated on the billet surface for laboratory hot‐rolling tests, and a corresponding rolling model is developed to validate its accuracy. The slab rolling model is established based on actual onsite rolling process parameters. The aim is to analyze the effects of different rolling conditions on the surface crack morphology and aspect ratio. The results indicate that variations in roll diameter (1400, 1300, and 1200 mm) influence crack propagation, with cracks unfolding earlier when the roll diameter is 1400 mm. At varying initial rolling temperatures (1300, 1200, and 1100 °C), cracks begin to unfold earlier at the highest temperature of 1300 °C. When examining different friction coefficients (0.4, 0.5, and 0.6), cracks unfold earlier at the highest coefficient of 0.6. Similarly, at different rolling speeds (3, 4, and 5 m s −1 ), cracks unfolded earlier at the highest speed of 5 m s −1 . Analysis of changes in crack depth and aspect ratio during rolling shows that the initial few passes have a greater influence on crack depth and unfolding. In the later stages of rolling, cracks continue to unfold, though the depth shows minimal variation, and the aspect ratio tends to approach zero.