Gel Cleaning in Heritage: Comparison of the Water Release among Gels and Traditional Pads

Water release is a crucial aspect when considering cleaning effects on water-sensitive materials. In conservation practice, a water-based cleaning method which limits water release is very often needed. Unfortunately, this is not accompanied by an appropriate measure of the effectively released water. In this paper, water release has been measured by comparing traditional cleaning formulations, such as paper pulp and sepiolite, with several gar gel formulations, used by both Italian and European conservators. The assessment has been carried out by the gravimetric method, using three different stone material specimens as reference: Noto calcarenite, Manciano sandstone and Black Bergamo limestone, whose porosity values and distributions are known. Moreover, water distribution has been evaluated by portable NMR tests. Different commercial agar gel products (Bresciani, CTS, Sigma), having different concentrations (3, 4, and 5%), application modes (rigid at room T or fluid warm gels, with and without inserting Japanese tissue paper), and geometry (horizontal in gravity force direction or vertical), have been compared to obtain a full scenario among different water release mechanisms present in real conservation works. The paper faces the important issue of preparing reproducible chemical or water pads as well, useful for further research aimed at comparing cleaning effects in heritage conservation. The most interesting quantitative results can be summarized as follows. The water release measured from paper pulp and sepiolite was found to be 2 to 4 times higher than from any tested agar gel. Water release decreases by increasing agar concentration; an increase in the agar concentration by 1% induces a decrease in water release in the range 16.98-66.88 g depending on the stone; the increase from 4% to 5% is more obvious with respect to that from 3% to 4%. It is possible to assess the effect of the presence of Japanese paper, which is able to reduce the water release from 18 to 76%, depending on the stone and on the agar used. The gravimetric results were also used in the preliminary calibration tests of a contact probe named System Unit Salinity Index (SUSI), recently patented and useful in providing humidity and salinity indexes in a given porous material.