Shock-driven three-fluid mixing with various chevron interface configurations

When a shock wave crosses a density interface, the Richtmyer–Meshkov instability causes perturbations to grow. Richtmyer–Meshkov instabilities arise from the deposition of vorticity from the misaligned density and pressure gradients at the shock front. In many engineering applications, microscopic surface roughness will grow into multi-mode perturbations, inducing mixing between the fluid on either side of an initial interface. Applications often have multiple interfaces, some of which are close enough to interact in the later stages of instability growth. In this study, we numerically investigate the mixing of a three-layer system with periodic zigzag (or chevron) interfaces, calculating the dependence of the width and mass of mixed material on properties such as the shock timing, chevron amplitude, multi-mode perturbation spectrum, density ratio, and shock mach number. The multi-mode case is also compared with a single-mode perturbation. The Flash hydrodynamic code is used to solve the Euler equations in three dimensions with adaptive grid refinement. Key results include a significant increase in mixed mass when changing from a single-mode to a multi-mode perturbation on one of the interfaces. The mixed width is mainly sensitive to the density ratio and chevron amplitude, whereas the mixed mass also depends on the multi-mode spectrum. Steeper initial perturbation spectra have lower mixed mass at early times but a greater mixed mass after the reflected shock transits back across the layer.