Analysis of the Heat Transfer Performance of a Buried Pipe in the Heating Season Based on Field Testing

Ground source heat pump (GSHP) systems have been widely used in the field of shallow geothermal heating and cooling because of their high thermal efficiency and environmental friendliness. A borehole heat exchanger (BHE) is the key part of a ground source heat pump system, and its performance and investment cost have a direct and significant impact on the performance and cost of the whole system. The ground temperature gradient, air temperature, seepage flow rate, and injection flow rate affect the heat exchange performance of BHEs, but most of the research on BHEs lacks field test verification. Therefore, this study relied on the results of a field thermal response test (TRT) based on a distributed optical fiber temperature sensor (DOFTS) and site hydrological, geological, and geothermal data to establish a corrected numerical model of buried pipe heat transfer and carry out the heat transfer performance analysis of a buried pipe in the heating season. The results showed that the ground temperature gradient of the test site was about 3.0 °C/100 m, and the temperature of the constant-temperature layer was about 9.17 °C. Increasing the air temperature could improve the heat transfer performance. The temperature of the surrounding rock and soil mass of the single pipe spread uniformly, and the closer it was to the buried pipe, the lower the temperature. When there is groundwater seepage, the seepage carries the cold energy generated by a buried pipe’s heat transfer through heat convection to form a plume zone, which can effectively alleviate the phenomenon of cold accumulation. With an increase in seepage velocity, the heat transfer of the buried pipe increases nonlinearly. The heat transfer performance can be improved by appropriately reducing the temperature and velocity of the injected fluid. Selecting a backfill material with higher thermal conductivity than the ground body can improve the heat transfer performance. These research results can provide support for the optimization of the heat transfer performance of a buried tube heat exchanger.