An Analysis of Lead Oxidation Mechanisms in the Volume of Vapor Bubbles

The article presents a kinetic model describing the lead vapor oxidation in the vapor bubble volume to produce lead oxide and hydrogen with their subsequent dissolution in the lead melt volume. The model is implemented in the approximation of homogeneous distribution of reagents and oxidation reaction products in the bubble volume. An analytical solution for stationary oxidation conditions is obtained. It is shown that vapor bubbles in the lead melt volume are a sort of chemical “microreactors” producing lead oxide and hydrogen, which subsequently dissolve in the melt volume. However, such hydrogen generation mechanism does not pose any threat for the primary coolant circuit of fast lead cooled reactors in terms of hydrogen accumulation and explosion hazard in view of essentially low intensity of the hydrogen generation source. The article presents the results of water to hydrogen conversion assessments carried out with the use of a homogeneous kinetic model for interaction of water vapor with lead vapor in the vapor bubble volume. The model incorporates mechanisms governing lead evaporation into the bubble volume, oxidation of lead vapor as it interacts with water vapor in the bubble volume, and dissolution of reaction products in the lead melt surrounding the bubble. One more important result of equilibrium thermodynamic computations is connected with a possible change in the composition of iron oxides in the melt after the injection of water from the steam generator leak into the melt. The ingress of water into the lead melt may cause a change in the composition of iron oxides, thereby increasing the fraction of hematite and decreasing the fraction of magnetite. This may entail a change in the composition of the protective oxide film on the structural steel surface to make it more brittle.