High strength C/Si‒Ni‒C composites fabricated by reaction melt infiltration with Si‒Ni alloy at lower temperature

Abstract Silicon‒nickel alloy (Si‒Ni) was first used for fabricating continuous carbon fiber reinforced ceramic matrix composites by reaction melt infiltration process. Based on Si‒Ni phase diagram, 66.7 at.% Si‒Ni was chosen, which has a lower liquidus temperature of 1115°C. The C/Si‒Ni‒C composites were infiltrated at temperature of 1270°C‒1390°C, and the prepared composite consists of C, SiC, NiSi, and NiSi 2 phases. The density of the composite is higher than 2.29 g/cm 3 and their open porosity is below 3%, indicating the composite was infiltrated completely by the Si‒Ni alloy. The C/Si‒Ni‒C composite exhibits significantly higher flexural strength and fracture toughness compared to the C/C‒SiC composite infiltrated with pure silicon at 1500°C. Specifically, the flexural strength and fracture toughness of the C/Si‒Ni‒C composite infiltrated at 1390°C increase by 140% and 300%, respectively. The improvement of mechanical properties contributed to the low reactivity between silicon‒nickel with carbon fibers, and the lower infiltration temperature, which can reduce degradation of carbon fiber as reinforcement. Moreover, the NiSi 2 and NiSi alloy phases in the C/Si‒Ni‒C composite replace the brittle silicon phase in the C/C‒SiC composite, which can obviously enhance the fracture toughness.