A hybrid experimental configuration for emissivity measurement at cryogenic temperatures

Abstract In cryogenic and high vacuum systems, radiation mode of heat transfer is the primary source of energy interaction owing to the wide temperature differentials and very low temperatures and pressures. Measurement of radiative properties such as emissivity is crucial in the design of cryogenic systems. Emissivity measurement at cryogenic temperatures requires careful consideration of the sample preparation and measurement conditions to ensure accuracy and reliability. Most experimental techniques developed so far are complex in their design and equipment, and they work only on a single measuring method. To address these challenges, this research has proposed a simpler and hybrid experimental setup that could employ both calorimetric and heat flux methods to directly measure the total hemispherical emissivity in the range 90 K–180 K. Experiments were conducted with five types of materials (black paint, stainless steel, aluminum foil, aluminized mylar foil, and copper sheet) by using both methods, and the results were validated with the literature data. The data obtained by calorimetric and heat flux methods for each sample showed a high level of consistency with each other, with a variation of only ±1.5%. Moreover, the discrepancy between the measured and literature data was within the acceptable range of 0.3%–10%. The total hemispherical emissivity of mechanically treated copper was higher than that of chemically polished copper by 11%. This simplified setup has incorporated all possible means to minimize heat leakages into and from the cryostat while maintaining accuracy. The obtained data can be used to accurately estimate the radiation heat loads in cryopumps and other cryogenic systems that use similar components.