Single-screw extrusion performance for LLDPE resin as a function of compression ratio

High-quality polyethylene film and sheet must be free of solid polymer fragments and degraded resin. Moreover, the products must be produced at high rates to minimize conversion costs. Thus, the extruder must produce a homogenous extrudate at the proper discharge temperature and pressure. The screw design and process operating parameters are key. A key screw design parameter is the compression ratio. This paper experimentally studies how the compression ratio affects a linear low-density polyethylene (LLDPE) resin extrusion process. A 2.8 compression ratio screw was optimal for LLDPE resin. Significant solid polymer fragments were observed in the extrudate for 2.8 to 3.6 compression ratio screws at 110 rpm and higher. For 2.0 and 2.4 compression ratio screws at less than 50 rpm, the internal pressures in the extruder were relatively low. At screw speeds 50 rpm and higher, the specific rates for all screws were higher than the calculated specific rotational rate, creating negative axial pressure gradients in the metering sections.