Study of the effect of SMAW welding speed on the microstructure and crystal stability of X70 steel using X-ray diffraction

This study investigates the impact of manual electric arc welding (SMAW) speed on the microstructure of X70 steel. Welding was performed at two distinct speeds: S1 = 20 mm/min and S2 = 35 mm/min, at the COSIDER BISKRA workshop in Algeria. X-ray diffraction (XRD) analysis was conducted on the welded zones to examine crystal orientation, size, dislocation density, and structural stability across different welding areas, including the base metal (MB), heat-affected zones (HAZ1 and HAZ2), and weld zones (WZ1 and WZ2). The XRD results revealed that key crystal peaks, such as {110} and {200}, retained their positions at both welding speeds, though variations in {110} peak intensity were noted. The lower welding speed (S1) resulted in a higher heat input, which enhanced crystal stability, increased crystal size, and reduced dislocation density. On the other hand, the higher speed (S2) produced lower heat input, leading to smaller crystal sizes, increased residual stresses, and a greater number of defects due to rapid cooling. These findings underscore the critical influence of welding speed on heat input, cooling rates, and their consequent effects on microstructure. The study highlights the importance of optimizing welding parameters to balance microstructural integrity, mechanical performance, and production efficiency.