Experimental Calculation of Added Masses for the Accurate Construction of Airship Flight Models

In recent years, interest in airships for cargo transport and stratospheric platforms has increased, necessitating accurate dynamic modeling for stability analysis, autopilot design, and mission planning, specifically through the calculation of stability derivatives, like added mass and inertia. Despite the several CFD methods and analytical solutions available to calculate added masses, experimental validation remains essential. This study introduces a novel methodology to measure these in a wind tunnel, comparing the results with prior studies that utilized towing tanks. The approach involves designing the test model and a crank-slider mechanism to generate motion within the wind tunnel, considering load cell sensitivity, precision, frequency range, and Reynolds numbers. A revolution ellipsoid model, made from extruded polystyrene, was used to validate analytical solutions. The test model, measuring 1 m in length with an aspect ratio of 6, weighing 482 g, was moved along rails by the crank-slider system. By increasing the motion frequency, structural vibrations affecting load cell measurements were minimized. Proper signal processing, including high-pass filtering and second-order Fourier series fitting, enabled successful virtual mass calculation, showing only a 2.1% deviation from theoretical values, significantly improving on previous studies with higher relative errors.