Influence of the water content in polyamide 6 on atmospheric pressure plasma jet pre-treatment and adhesion for adhesive bonding

Abstract To quantify the influence of absorbed water in PA6 on the pre-treatment and bonding process, an unfilled and unreinforced PA6 material is investigated in a dried and saturated state. The material is pre-treated by atmospheric pressure plasma jet (APPJ) with varying jet distances. The surfaces are investigated by contact angle measurements, DSC and FTIR to detect molecular and morphological changes in the surface. To evaluate the bonding strength, samples are bonded with a two-component polyurethane adhesive and a two-component acrylate adhesive and tested in a lap shear and a tensile configuration. The results show that water content has a significant influence on the effectivity of the pre-treatment process and the resulting bonding strength and failure mechanism. The adhesion is majorly affected, however these effects do not influence the macroscopic wetting behavior and cannot be measured in contact angles. FTIR spectra and DSC scans do not show significant changes in molecular groups or crystallinity that would explain the observed adhesion improvement in dried samples. High bonding strength is only achieved with adherents at low water content.