Functional design of PGMA-co-PDFHM/Ti3C2Tx MXene composite materials for anti-icing in simulated outdoor environment

To improve anti-icing traits of outdoor coatings, a synergy between photothermal and hydrophobic anti-icings was utilized to fabricate copolymer/Ti₃C₂T_x MXene composite coatings with good transparency and adhesion. MXene contributes to photothermal trait from local surface plasmon resonance effect. Copolymer enables hydrophobicity from perfluoroalkyls-induced low surface energy and high surface roughness. An increase in MXene dose results in an increased surface roughness. With 140.0 ± 2.2° of water contact angle and 70% of light transmittance, the optimal film bears 2 wt% of MXene. High MXene dose results in large temperature-increase of film under sunlight. After 15 min of sunlight exposure, the temperature of optimal film surface in icing simulation increases from - 18 ℃ to 7.2 ℃. After 48 h of acid immersion, the temperature-increase of optimal film surface based on 300 s of sunlight irradiation reaches 28.7 ± 1.2 ℃. After 48 h of ultraviolet irradiation, the temperature-increase of optimal film surface is 30.7 ± 0.8 ℃. This surface has a water contact angle of 132.7 ± 1.1° after 48 h of acid immersion. This study gives impetus to a preparation of various composite coatings for outdoor anti-icing/deicing.