Effect of eucalyptus globulus pulp properties on fock reactivity

Abstract Dissolving-grade pulps serve as the primary material for producing regenerated cellulose fibers, and their utilization is steadily increasing. Despite extensive research efforts, it remains necessary to deepen our understanding of the inherent factors that impact pulp reactivity apart from the well-known degree of polymerization. The Fock reactivity test is commonly used to quantify the reactivity of cellulose pulp by measuring the percentage of cellulose that reacts with carbon disulfide. Dissolving pulps typically require a reactivity of over 90%. Hemicellulose content, intrinsic viscosity, cell wall porosity, crystallinity, and accessible area of four different pulps were characterized and distinct treatments were employed to try to separate the effect of different pulp properties and assess their effect on Fock reactivity. Hemicelluloses removal by xylanase and cold caustic treatments (86% removal) increased the Fock reactivity by 30%, from 55.7% to 71.3%. Assuming the hemicelluloses are fully accessible by the CS 2 , cellulose reactivity increased from 35.6% to 69.5%,but at the expense of an intrinsic viscosity decrease from 990 cm 3 /g to 689 cm 3 /g. This unexpected intrinsic viscosity decrease can be due to the cellulose de-shielding effect provoked by hemicellulose removal and some cellulose degradation during cold caustic extraction. Vibrational impact ball-milling applied on a pulp with 5% hemicellulose content notably boosted Fock reactivity by 56%, from 54% to 84.5%, but two pulp properties, intrinsic viscosity, and crystallinity, decreased concurrently due to the high-energy treatment. This phenomenon complicates identifying a direct correlation between heightened reactivity and a single parameter. To address this, endoglucanase treatment was used to separate intrinsic viscosity from crystallinity, clarifying their contributions to changes in Fock reactivity. Unfortunately, the effect of a given physical or bio/chemical pulp treatment affects more than one pulp property, always including the cellulose degree of polymerization, which has made it difficult to isolate the pulp properties that affect Fock reactivity. Several processes have been tested to obtain pulp with dissolving potential.