Numerical Modeling of a Primary Heat Exchanger in sCO2 Power Cycles for Thermal Energy Storage Systems

Abstract Renewable energy sources are the key for long-term decarbonization of energy. However, the intermittent nature of renewables does not always meet the energy demand in the electrical grid. Thus, electrical heated thermal energy storage systems (TES) coupled with sCO2 power cycles are investigated at Helmholtz-Zentrum Dresden-Rossendorf as a possible solution to balance this mismatch. In this study, a printed circuit heat exchanger (PCHE) is considered as candidate for the 1 MW primary heat exchanger, given the mechanical challenge induced by drastic pressure difference between the hot fluid of the TES and the cold fluid of the power cycle. The present work consists of two parts, one elaborates a one-dimensional (1D) model in order to optimize the PCHE regarding the pump power required to compensate the pressure loss. It was found that the hot fluid coming from the TES accounts for 80% of the total pump power after optimization because of its low density and its high mass flow rate. Furthermore, three-dimensional simulations by computational fluid dynamics (CFD) were done and compared to the results from the 1D model to ensure its validity. It was observed that the results from the 1D model and the CFD simulations are consistent, with a slight potential deviation in the calculation of the pressure profile.