3D-printed polarization-independent low-cost flexible frequency selective surface based dual-band microwave absorber

Abstract A 3D-printed polarization-independent low-cost lightweight and flexible frequency selective surface based dual-band microwave absorber is presented in this paper. Two concentric square loops fabricated at different heights using 3D printing technology are responsible for exhibiting dual-band responses at 3.32 GHz (S-band) and 5.46 GHz (C-band) with more than 97% absorptivities. The corresponding full widths at half maximum bandwidths are observed as 230 MHz (3.21–3.44 GHz) and 450 MHz (5.27–5.72 GHz). The proposed topology is polarization-insensitive owing to the four-fold symmetry. The absorption phenomenon is explained with the analysis of current distributions at the surface and impedance curves at the frequencies of resonance. Further, the performance has been evaluated for both planar and curved surfaces with different angles of curvature, and the good agreement between the measured and simulated responses confirms the flexible behavior of the proposed structure.