An investigation on effect of tramp elements and solidification processing on homogenization kinetics of AA 7xxx series aluminum alloys

AA 7068 Aluminum alloy is produced via conventional solidification (CS) and controlled diffusion solidification (CDS) processing and homogenized at 450 °C for 6 and 12 h. Optical microscopy (OM) and scanning electron microscopy (SEM) equipped with an energy dispersive x-ray spectroscope (EDS) were used to examine the as-cast and homogenized samples. It was found that although the CS sample is more chemically homogenized in the as-solidified state, the CDS sample exhibits a higher homogenization rate during the treatment. The calculated phase diagram (CALPHAD) methodology was employed to study the effect of silicon and iron on the solidification path and homogenization of the alloy. Silicon consumes magnesium atoms on the surface of the α-Al phase to form the Mg 2 Si phase. Therefore, the magnesium concentration on the α-Al phase required for the formation of the σ phase must be increased. Calculations shows that all the Mg atoms at this stage are completely supplied from the bulk of the αAl phase. It can be hypothesized that during the last stage of solidification, a solid/liquid diffusion couple can be created between the primary αAl and the remaining liquid for several minutes (4 min at a cooling rate of 0.2 o C/s). As a result of the activation of this couple, the Mg atoms diffuse from the α-Al bulk to its surface, and vacancies diffuse from the surface to the bulk, forming a line of Kirkendall voids. With CDS processing, the surface of the primary phase is less Mg-concentrated than that in the CS process and this significantly reduces the formation of the Mg 2 Si phase. Conversely, the vacancy and Mg concentration of the αAl phase in CDS is higher than that of CS and this lets other alloying elements other than Mg diffuse to the primary phase, decreasing the homogenization time. The presence of Si in the alloy leads to the formation of the Mg 2 Si phase, which significantly reduces the final Mg concentration in the α-Al phase after full homogenization. In the pure alloy, the Mg concentration is 2.42 wt%, while in the FeSi-containing alloy, it is reduced to 1.58 wt% due to solid solution and dispersion strengthening mechanisms. Through CDS processing, the negative impact of Si can be reduced by disrupting the mechanism of Mg 2 Si formation.