Four-wave mixing in silicon nanophotonic waveguides and microring resonators: influence of two-photon absorption

Four-wave mixing (FWM) in silicon photonics offers promising applications in optical signal processing, wavelength conversion, and quantum photonics, necessitating a comprehensive understanding of its underlying physics and limitations. Stimulated four-wave mixing in silicon photonic wire waveguides has been investigated theoretically by considering two-photon absorption, free carrier absorption, and free carrier dispersion, etc., operating near λ∼1550 nm. It has been shown that these effects severely degrade the performance when operating at higher pump power levels. We present exact numerical calculations of idler wavelength conversion efficiency and bandwidth taking into account the abovementioned nonlinearities, to show the effects of various parameters within the waveguide structure. We extended to investigate silicon photonic microring resonators in terms of the four-wave mixing performance of high-Q-value microring resonators, which are very promising as photon sources (spontaneous four-wave mixing) for large-scale quantum photonic circuits. Our analysis illustrates the limitations of analytical models in describing FWM in ring resonator behavior at a moderate input power level, necessitating a rigorous numerical approach. Experimentally, we demonstrate stimulated FWM (1525 nm≤λp≤1575 nm) in a silicon photonic wire with a cross-section of 500 nm×220 nm and with a small waveguide length of 2 mm. The idler-to-signal conversion efficiency of about −35 dB has been measured for an approximate launched pump power of 30 mW. The conversion efficiency is improved further in the microring resonator as predicted by the simulation results.