Optimization of Material Removal Rate and Wear Rate in EDM Machining of Inconel 625 Using a Novel Nano Al-Ni Composite Electrode: A Response Surface Methodology Approach

The electric discharge machine is a novel machining technique. When the tool and the work item do not communicate. Components composed of difficult-to-machine hard materials. In the current experimental inquiry, the process factors that influence the machining concert process and its effectiveness are explored. The response table for each set of machining limitations is used in conjunction with the response surface methodology in the research to determine the appropriate levels of machining factors. The work's machining input parameters are optimized for maximum material removal rate (MRR) and reduce the electrode wear rate (EWR) when electro-discharge machining Inconel 625 using the tool Nano Al-Ni composite electrode. Another analysis of variance is to identify the factors causing the different answers mentioned above. EDAX was also used to investigate the material composition of the workpiece. Machined workpiece surfaces were evaluated using scanning electron microscopy to assess surface accuracy and microstructural characteristics (SEM). The following conclusions may be drawn from this work. The MRR parameter that is most affected is pulse off time. As pulse-off time lengthens, MRR increases. According to the response graph, the greatest MRR value that can be attained under the ideal parameters of Ip = 8A, T-ON = 50μs, and T-OFF = 100μs is 0.0115 g/min. The magnitudes of MRR range from 0.0091 to 0.044 g/min. Impact of T ON and T OFF: Higher EWR is 0.0022 g/min is seen in runs with T ON = 70 μs and T OFF = 100 μs.