Divertor erosion at ASDEX Upgrade during helium plasma operations

• Divertor erosion measured during He plasma discharges on AUG with marker samples. • Pt marker samples embedded in W divertor tiles exposed to L- and H-mode plasmas. • Higher erosion than with D plasma: He H-mode eroded the full 50 nm Pt layer. • High erosion far in the SOL unlike with D that has most erosion near strike point. • No Pt re-deposition detected poloidally in between the markers. The effect of helium plasma operation on the erosion of plasma-facing components at the low-field side divertor of ASDEX Upgrade was investigated during the 2022 helium experimental campaign. A set of tungsten-covered graphite samples with small platinum marker spots was exposed to both L-mode and H-mode plasma discharges. The highest net erosion of over 1.1 nm/s was observed around the H-mode strike point similar to the case in deuterium plasma. Significant helium inventories of about 6 × 10 16 He/cm 2 were measured in the scrape-off layer region of the divertor. Impurity deposition including boron and deuterium showed a distinct peak up to 2.4 × 10 17 B/cm 2 and 1.0 × 10 16 D/cm 2 between the strike points, and significant boron inventories up to 5.9 × 10 16 B/cm 2 were also measured on the scrape-off layer side of the H-mode strike point. Platinum re-deposition was not detected between the marker spots, suggesting that it occurs only very locally within the markers. Overall erosion was, as expected, higher than in deuterium discharges, and it also remained comparatively high towards the scrape-off layer, unlike with deuterium.