Coupling adsorption and in-situ Fenton-like oxidation by iron-containing low-grade attapulgite clay towards organic pollutant removal: From batch experiment to continuous operation

Coupling adsorption and in-situ Fenton-like oxidation process was developed for Methylene blue (MB) using refined iron-containing low-grade attapulgite (ATP) clay, and the removal mechanism was investigated. The MB was initially adsorbed on the porous ATPs, and then the enriched MB was removed by the H 2 O 2 -assisted Fenton-like oxidation with the iron-containing ATP catalyst. Under optimal conditions, the ATP powder exhibits the maximum removal efficiency of 100% with negligible iron leaching (1.5 mg L -1 ) and no sludge formation. Furthermore, polysulfone/ATP (PSF/ATP) pellets were fabricated through a water-induced phase separation process to construct a fixed-bed reactor (FBR) for continuous contaminant removal. For the first cycle, the maximum adsorption capacity was 15.5 L with an outlet MB concentration of 1.973 mg L -1 (˂ 2 mg L -1 , GB4287-2012) using the PSF/ATP pellets containing 50.0 g of ATP powders, and the maximum Fenton-like oxidation capacity was 35.5 L with the outlet concentration of 0.831 mg L -1 . After five cycles, the total treated volume of the MB solution was ca. 255 L, and the efficiency remained above 99%. After 10 hours of continuous treatment towards practical resin industrial wastewater, the chemical oxygen demand (COD) removal efficiency was still measured at 83.05%, costing 0.398 $ m -3 . These results demonstrate the practical applicability of iron-containing low-grade ATP clay for textile water treatment. Coupling adsorption and in-situ Fenton-like oxidation by iron-containing low-grade attapulgite (ATP) from powder to polysulfone/ATP pellets towards organic pollutant removal: From batch experiments to continuous operation. • A coupling approach for adsorption and in-situ Fenton-like oxidation was developed. • Iron-containing low-grade attapulgite clay was used for organic pollutant removal. • Powder to pellet was investigated for batch experiment and continuous operation. • Practical resin industrial wastewater was removed in a continuous fixed-bed.