A comparison of wire-feed additive manufacturing and hybrid additive/subtractive manufacturing of high nitrogen steel

High nitrogen austenitic stainless steel, referred to as high nitrogen steel (HNS), has been widely studied and applied because of its excellent properties such as high strength, good plasticity and toughness. However, its high nitrogen content makes the deposition metal face problems such as nitrogen porosity, nitrogen escape and loss when it is processed by additive manufacturing (AM), which has a negative impact on the mechanical properties. Two thin-walled specimens without obvious defects were obtained by wire-feed AM and hybrid additive/subtractive manufacturing (HASM) using the self-made HNS wire with 0.7 wt% N, respectively. The porosity, microstructures and tensile properties of thin-walled specimens were compared. The porosity of the two specimens was tested by an industrial computed tomography (CT) system. The defect volume ratio and the diameter of the largest pore of HASM specimen were reduced about 54% and by 46.6% than those of wire-feed AM, respectively. The morphology of ferrite at different height of both specimens was different including skeletal, lathy and granular. The tensile strength of HASM specimen was better than that of wire-feed AM, which is mainly attributed to the decrease of porosity and grain size.