Numerical simulation of the creep of a turbine blade made of a monocrystalline alloy

The article is devoted to the creep model of a monocrystalline alloy and the development of a methodology for identifying material parameters based on the results of physical experiments. A finite element analysis of the creep of a gas turbine engine blade was performed. Creep is one of the most dangerous types of deformation in the operating conditions of turbine blades. In the process of studying the problems of assessing the strength of turbine blades of aircraft engines and power plants, special attention should be paid to the study of stress redistribution during creep. The characteristics of the crystallographic structures of modern turbine blades have a very significant influence on the progress of the crack development process during engine operation. To date, turbine blades are manufactured by the method of single-crystal casting. This type of blade material structure is characterized by orthotropic mechanical properties. This study considers the steady-state creep model of an anisotropic heat-resistant single-crystal alloy with cubic symmetry. The authors carried out a numerical simulation of the material parameters using the well-known literary creep properties of single crystals. An algorithm is described that allows you to determine some creep characteristics of single crystals. The parameters of the given ratios can be obtained after conducting direct experiments, or based on micromechanical analysis, using the example of composite materials. The authors calculated the creep constants of a typical heat-resistant monocrystalline alloy as a result of the approximation of its creep curves, which were obtained experimentally. Based on the Norton-Bailey equation and using the Maple Release 2021.0 calculation complex, a graph of the dependence of the rate of creep deformation on the level of load applied to the material was plotted, and the minimum rate of deformation and creep constants were also determined. The results of the calculations were used for finite-element simulation of creep on the example of a solid-state model of a high-pressure turbine blade. Several series of calculations were carried out on the basis of the ANSYS Workbench complex, in particular, the calculation of the elastic problem when the blade is loaded by centrifugal forces, as well as the accumulation of creep deformations at different exposure times. Graphs of the change in equivalent stresses and creep deformations as a function of time are plotted.