МОДЕЛЮВАННЯ ТА ОПТИМІЗАЦІЯ РЕЖИМУ ТЕРМООБРОБКИ ТРУБЧАСТИХ ЕЛЕМЕНТІВ ФЕРМЕННИХ КОНСТРУКЦІЙ ЛІТАЛЬНИХ АПАРАТІВ З ВУГЛЕПЛАСТИКУ

The article analyzes the current state of development of dimensionally stable tubular elements (TE) and technological problems arising during their production. It is shown that along with empirical methods of studying the influence of various technological schemes on the dimensional stability of tubular elements, it is useful to use the optimal temperature-time mode for heat treatment and, based on it, select the optimal technological scheme. Modeling and determination of the optimal mode of heat treatment of tubular elements were performed. The study of the TE heat treatment mode was carried out in two stages, first by methods of mathematical modeling and optimization, and then by empirical enumeration of various technological schemes. At the first stage, the material properties, which are parameters of the mathematical model, were studied, and the optimal curing modes were calculated. At the second stage, the calculated optimal curing modes were supplemented with various technological methods that cannot be mathematically modeled, and a study was carried out on the influence of the resulting combined heat treatment mode on the geometric characteristics and dimensional stability of carbon fiber TE. The mathematical model of the process of heat treatment and curing of TE in a heat chamber, when heated by a heating air flow, is a system of differential equations: thermal conductivity and curing kinetics. A mathematical model of the process of heat treatment of tubular elements manufactured by the winding method is proposed, the ways of optimizing the curing mode of carbon fiber TE are shown. A numerical calculation of temperature-conversion fields during curing and calculation of optimal curing modes of tubular elements are performed taking into account various process schemes. The values of heat capacity C and thermal conductivity l are calculated depending on the temperature T, the degree of curing b and the filling coefficient g, Безфітингова ферма з вуглепластику Безфітингова ферма з вуглепластику Безфітингова ферма з вуглепластику the power of heat release W and the thermal effect of the curing reaction Q of carbon fiber. Optimum curing modes for a plate made of composite polymer material are obtained, calculated from the data obtained as a result of studying material samples. Temperature-time curing modes are obtained, which are optimized for different thicknesses of the studied material. The statistical hypothesis about the significance of the influence of the process flow chart and reinforcement pattern on the wall thickness of a tubular element and its compressive strength was proved by the dispersion analysis method. The influence of process flow charts and heat treatment modes on the geometric and mechanical characteristics of carbon fiber tubular elements of aircraft truss structures was studied. The statistical hypothesis about the significance of the influence of the process flow chart and reinforcement pattern on the deviation of the wall thickness of tubular elements and their strength characteristics was tested. The significance of the influence of process flow charts with different heat treatment modes on the average wall thickness of a carbon fiber tubular element was statistically proven.