Thermodynamic–kinetic calculations and dilatometric verification of the martensitic and bainitic transformations in 4% medium-Mn steel

Abstract The present study investigated the theoretical and experimental phase transitions phenomena during continuous cooling and isothermal holding above and below M s temperature in 4 mass. % Mn medium-Mn steel. The thermodynamic–kinetic calculations were performed using JMatPro software, and phase transformations were recorded using a BÄHR high-resolution DIL805A/D dilatometer. The research covered continuous cooling rates from 60 to 0.05 °C s –1 and isothermal holding temperatures in a range between 420 °C and 230 °C. The issues related to both modelling and dilatometric methodology were discussed. The CCT and TTT diagrams were prepared on the basis of dilatometry and compared with the results of light microscopy and hardness tests. The alloy containing about 4 mass.% Mn and 0.22% Mo exhibited very high hardenability as only continuous cooling with rates lower than 1 °C s –1 allowed the bainitic transformation to be initiated. The bainitic transformation is accelerated after passing the M s temperature. Both the incubation time and the time needed to complete the transformation were significantly reduced (the incubation time from 100 s to below 1 s and the completion time from over 4000 s to below 1000 s). The obtained microstructures were homogeneous and refined.