Measurement of Oscillatory and Dissipative Resonator Characteristics of Solid-State Wave Gyroscopes: Algorithms for Operational Correction of Systematic Signal Drift

The article discusses the possibilities of increasing the output signal accuracy of integrating solid-state wave gyroscopes manufactured with a reduction in the requirements for the residual characteristics of the multi-frequency and multi-factor ratios of their resonators, as well as for the centering of the control ring electrode. These capabilities involve the use of a more complex output function that includes an additional part due to the effect of these errors on the systematic drift function. However, its formation requires introduction of an interval shutdown of the parametric excitation system so as to increase the purity of identification of the listed factors. To reveal this topic, the following is sequentially described: mathematical formulation of the problem; general analysis of the systematic drift of the integrating gyroscope signal caused by mechanical errors in the design of its resonator; autonomous algorithmic reduction of the influence of the dominant residual differentials in the mode of interval disconnection of excitation; autonomous algorithmic reduction of the influence of the dominant residual frequency difference in the mode of interval disconnection of excitation; simultaneous algorithmic compensation of the influence of residual Q and Frequency in the interval disconnection mode of excitation; estimation of the signal drift component of the integrating gyroscope, due to errors in the control loops, as well as the possibility of its reduction. The analysis of these problems is carried out on the basis of a model of wave processes in the gyroscope resonator, obtained only on the basis of the laws of classical mechanics. There were no additional errors due to the imperfection of the electrical circuits for processing measurement and control signals. Various computational schemes discussed in the article can also be useful for performing operational adjustments of the gyroscope measurement system, which may be required as a result of the design aging factor, as well as after its intensive use in a wide range of external disturbances.