A Study on the Coarse-to-Fine Error Decomposition and Compensation Method of Free-Form Surface Machining

To improve the machining accuracy of free-form surface parts, a coarse-to-fine free-form surface machining error decomposition and compensation method is proposed in this paper. First, the machining error was coarsely decomposed using variational mode decomposition (VMD), and the correlation coefficients between the intrinsic mode function (IMF) and the machining error were obtained to filter out the IMF components that were larger than the thresholding value of the correlation coefficients, which was the coarse systematic error. Second, the coarse systematic errors were finely decomposed using empirical mode decomposition (EMD), which still filters out the IMF components that are larger than the thresholding value of the set correlation coefficient based on the correlation coefficient. Then, the wavelet thresholding method was utilized to finely decompose all the IMF components whose correlation coefficients in the first two decomposition processes were smaller than the threshold value of the correlation coefficient set. The decomposed residual systematic errors were reconstructed with the IMF components screened in the EMD fine decomposition, which gave the fine systematic error. Finally, the machining surface was reconstructed according to the fine systematic error, and its corresponding toolpath was generated to compensate for the machining error without moving the part. The simulation and analysis results of the design show that the method has a more ideal processing error decomposition ability and can decompose the systematic error contained in the processing error in a more complete way. The results of actual machining experiments show that, after using the method proposed in this paper to compensate for the machining error, the maximum absolute machining error decreased from 0.0580 mm to 0.0159 mm, which was a 72.5% reduction, and the average absolute machining error decreased from 0.0472 mm to 0.0059 mm, which was an 87.5% reduction. It was shown that the method was effective and feasible for free-form surface part machining error compensation.