Effects of beads and shot peening intensity on the surface integrity and fatigue performance of a stainless gear steel

Shot peening was performed on stainless gear steel using multiple kinds of beads at multiple intensities. The effects of shot peening on surface integrity and the rotational bending fatigue performance were tested with the crack origin location observed. The results showed that the average surface roughness increases from Sa0.408 μm to Sa1.165 μm as the shot peening intensity increases, which does not necessarily lead to an increase in surface stress concentration coefficient. The compressive residual stress profile and the depth of the hardened layer increase with the increase of shot peening intensity. During ceramic bead peening, the fatigue improvement, with a maximum of 25 times, increases with the raise of intensity (0.06–0.20 mmA), while the fatigue improvement decreases when intensity (0.2–0.30 mmA) increases using cast steel shot. Based on ceramic shot peening, a method was proposed to predict the origin location of rotational bending fatigue cracks of gear stainless steel, in which the effects of surface stress concentration, compressive residual stress, and external load introduced were all considered. By using the superposition method of external load and residual stress, the maximum actual stress corresponding depth is obtained, which is the origin position of the rotational bending fatigue crack.