Temperature-insensitive and cost-effective distributed NP-Doped optical fiber sensors

• Temperature insensitive Transmission-Reflection Analysis distributed sensor. • NP-doped fibers in conjunction with Fiber Bragg Gratings as wavelength filters. • Multiple NP-doped fibers multiplexed in one channel for multiple perturbation detection. This paper presents the development of a cost-effective distributed optical fiber sensor for temperature-insensitive assessment of mechanical disturbances along an optical fiber cable. The proposed sensor system uses a nanoparticle (NP)-doped optical fiber with enhanced Rayleigh backscattering to provide higher sensitivity and spatial resolution using the transmission and reflection analysis (TRA) approach, where the transmitted and backscattered optical powers are analyzed as a function of the mechanical disturbance. In addition, Fiber Bragg Gratings (FBGs) are used as wavelength filters to provide the wavelength division multiplexing of the proposed device, which enable the use of 3 different NP-doped optical fiber sections for simultaneous detection of multiple curvature conditions in a cost-effective distributed sensing approach. The sensor characterization tests are performed by means of applying curvature angles from 360° to 1080° at different positions along NP-doped fibers (namely 25 mm, 100 mm and 175 mm) at 4 different temperatures of 25 °C, 30 °C, 40 °C and 50 °C. The results indicate the feasibility of the proposed approach, where the temperature variations lead only to a wavelength shift of the Bragg wavelength, whereas the mechanical disturbances (the curvatures) lead only to variations in the transmitted and reflected optical powers. Thus, by analyzing the transmitted and reflected optical powers in conjunction with the Bragg wavelength shift, it is possible to estimate both the mechanical disturbance amplitude (i.e., curvature angle) and the position along each NP-doped optical fiber section. Results indicate a relative error of around 3 % and 4 % for the mechanical disturbance location and absolute value, respectively. Moreover, the temperature cross-sensitivity in this case is below 2 % considering both amplitude and location of the mechanical disturbance. The proposed approach can be applied in structural health monitoring of different types of structures by integrating the fibers in the structures themselves with the possibility of measuring the strain distribution along the fibers (instead of in different points along the fiber) using a lower cost hardware when compared with similar distributed optical fiber sensing approaches.