EVALUATION OF TECHNOLOGICAL PLASTICITY OF HIGH BORON CORROSION-RESISTANT STEEL DURING HOT DEFORMATION OF PIPES USED FOR SPENT NUCLEAR FUEL STORAGE

Statement of the problem. The sustainable development of the global nuclear power industry in the future depends on how effectively the problems of radiation safety and nuclear proliferation are addressed. Such problems occur, among other things, at the final stage of the nuclear fuel cycle – spent fuel management. This task is currently on the agenda of both the international community and national governments of countries that develop or intend to develop nuclear energy [1−3]. Today, in connection with ensuring the safety of nuclear energy, boron-containing steels are widely used in the world practice as a material for biological protection and for the manufacture of special equipment parts. This is due to the fact that the B10 isotope in steels provides neutron capture [4]. Hexagonal pipes made of high-boron steel were needed to shield the support cover of the compacted spent fuel storage facility at nuclear power plants. Corrosion-resistant steels alloyed with boron are widely used in the nuclear power industry due to their special nuclear properties. During the operation of nuclear power plants, fuel assemblies that have served their useful life must be stored in special storage facilities using containers – hexagonal tubes made of 04Сr14Ti3B2V steel. To reduce costs during in the construction and operation of NPPs, part of the spent nuclear fuel management should be performed at Ukrainian enterprises. This will provide a significant import substitution effect. To manufacture hexagonal tubes from 04Сr14Ti3B2V steel according to the ingot-hot deformation-profiling-heat treatment scheme, it is necessary to develop the parameters of hot deformation and subsequent technological operations. The use of these pipes in compacted spent fuel storage facilities of NPPs will allow to increase the storage capacity by 2 times, which will give a significant national economic effect Material and methods of research. Material used for the study was steel 04Сr14Ti3B2V (CS-82), smelted using two variants (vacuum-induction – “VI” and vacuum-induction followed by vacuum-arc remelting – (“VD”). Steel grade 04Сr14Ti3B2V belongs to high-alloy, corrosion-resistant ferritic steels with a high boron content of up to 2 %. The method of differential thermal analysis was used to study the phase transformation temperatures in the steel. X-ray diffraction and micro-X-ray spectral analysis were used to assess the phase state. The steel samples were tested for weldability After cooling, the welded samples were subjected to X-ray transmission [5]. Hot twisting tests and mechanical tests at high temperatures were also performed. The macro- and microstructure of the metal was studied. Results. The macro- and microstructure of steel was evaluated depending on the smelting method. The phase composition of the steel was studied. The study of the plastic properties of steel ChS-82 by means of penetration and hot twisting tests showed that the temperature range of maximum plasticity is in a wide range (from 1 025 to 1 150 0C) with a rather low resistance to deformation. During hot deformation in the temperature range of 1 175 0C and above, metal fracture was observed along the grain boundaries at the melting points of the Cr−Fe−B boride phase. The optimal temperature range for hot deformation of steel ChS-82 is 1 000−1 050 ⁰С. Scientific novelty. For corrosion-resistant high boron steel used for spent nuclear fuel storage, the temperature range of hot deformation was selected and the structural and phase composition was estimated, which will allow deforming the metal on the piercing mill and manufacturing pipes.