Transient behavior of ablation and swelling for C/C composite and HfC-coated C/C composite in an arc-heated wind tunnel

This study investigated and modeled the transient behavior of surface recession, defined as the difference between ablative length and swelling length, for thermal protection materials within a high-enthalpy flow. Needle punch carbon-carbon (NPCC) and hafnium carbide coated carbon-carbon (HfC-coated NPCC) were exposed to high-enthalpy flow with a heat flux of 7.67 MW/m 2 generated by an arc-heated facility. The NPCC and the HfC-coated NPCC represent an ablative surface and a non-ablative surface, respectively. Surface recession histories were estimated through an image analysis and visualizations monitored by a high-speed camera. Moreover, measured data including surface temperature histories, mass loss, and total length were presented. We proposed the models for the transient recession on the ablative surface and the non-ablative surface considering the ablation and the swelling. The ablative length was calculated using non-dimensional parameter B′, which computes ablation rates under equilibrium air conditions. While B’ modeling accurately predicted the ablation rates, it could not reflect the swelling phenomenon during an initial heating phase. The swelling was modeled with consideration of the thermal expansion. Specifically, the effect of increased porosity near the ablative surface was incorporated into the thermal expansion coefficient. The model developed in this study well agreed with the experimental data.