Three-Dimensional Probe Mispositioning Errors Compensation: A Feasibility Study in the Non-Redundant Helicoidal Near to Far-Field Transformation Case

A feasibility study on the compensation of 3D mispositioning errors of the probe occurring in the characterization of a long antenna, via a non-redundant (NR) near to far-field (NTFF) transformation with helicoidal scan, is conducted in this article. Such types of errors can result from imperfections in the rail driving the linear motion of the probe and from an imprecise synchronization of the linear and rotational movements of the probe and the antenna when drawing the scan helix. To correct them, an approach, which proceeds through two steps, is proposed. The former step uses a technique called cylindo rical wave (CW) correction for compensating the phase of the near-field (NF) samples, which, owing to the rail imperfections, result in not being acquired over the measurement cylinder surface. The latter exploits an iterative scheme to restore the samples at the sampling points required by the adopted NR representation along the scan helix from those obtained by applying the CW correction technique and impaired by 2D mispositioning errors. The so compensated NF samples are then effectively recovered via a 2D optimal sampling interpolation (OSI) scheme to accurately obtain the input data required to carry out the standard cylindrical NTFF transformation. The OSI representation is determined here by assuming a long antenna under test as enclosed in a prolate ellipsoid or cylinder ending into two hemispheres (cigar) in order to make, depending on the particular geometry of the considered antenna, the representation effectively non-redundant. The reported numerical simulation results show the capability of the proposed approach to compensate even severe 3D mispositioning errors, thus enabling its usage in a real measurement scenario.