Mode II fracture behavior of glass fiber composite-steel bonded interface–experiments and CZM

• Mode II fracture of GFRP-steel interface characterized in 3 and 4-point ENF tests. • Interfacial or adherend failure controlled by orientation of bi-material specimens. • New DIC and shear-strain based method to measure mode II crack length and CTOD. • Four-linear traction-separation law derived from DIC measurements and iterative FEA. • Softening used in CZM to simulate mechanical interlocking of bi-material interface. The dominant failure mode was characterized as debonding in the novel non-welded wrapped composite joint made with GFRP composites wrapped around steel sections. Glass fiber composite-steel three-point end notched flexure (3ENF) and four-point end notched flexure (4ENF) specimens were utilized to experimentally investigate mode II fracture behavior of this composite-steel bonded interface. Two new methods were proposed with the help of digital image correlation (DIC) technique to quantify fracture data during the tests: 1) the “shear strain scaling method” to quantify the crack length a ; 2) the asymptotic analysis method based on the longitudinal displacement distribution along the height of the specimen at the pre-crack tip to quantify the crack tip opening displacement (CTOD). To numerically simulate the mode II fracture behavior, a four-linear traction-separation law was proposed in the cohesive zone modeling (CZM) where the softening behavior with a plateau was defined by the authors between traditionally considered initiation and fiber bridging behavior. The experimental and numerical approaches were validated mutually through good matches between the test and FEA results. 3ENF test provided good insight into softening behavior while 4ENF contributed to quantification of fiber bridging. These findings contribute to a more comprehensive characterization and understanding of the ductile fracture behavior of bi-material bonded joints, especially in mode II failure scenarios.