Petrogenesis of the Deccan high-Mg basalts and picrites

Abstract Tholeiitic basalts and picrites from the Deccan Traps were used to constrain the pressure and temperature conditions of mantle melting for their origin. Clinopyroxene thermobarometry indicates that all Deccan tholeiites crystallized at low pressures in the upper crust (< 6 kbar/1047–1221 °C). In comparison, the Deccan alkalic rocks crystallized at pressures up to ~ 12.7 kbar. Rare samples of the tholeiites plot on their low-pressure olivine-plagioclase-clinopyroxene (Ol-Pl-Cpx) cotectic boundaries or olivine control lines in phase diagrams. These samples represent unmodified magmatic liquids. Primary magmas of the basalts that plot on their cotectic boundaries were modeled through reverse fractionation by incrementally adding equilibrium Ol + Pl + Cpx, Ol + Pl and Ol ± spinel, until the liquid was multiply saturated with lherzolite at a high pressure. The high-Mg basalts are contaminated with continental crust. Hence, a crustal partial melt was simultaneously subtracted according to energy constraints at each reverse fractionation step for these samples. The results show that the high-Mg basalts are 41–53% fractionated and 1–6% contaminated, and the low-Mg basalts are 63–67% fractionated. Their primary magmas were last equilibrated with spinel lherzolite at 10–13 kbar/1289–1333 °C. A picrite and two very high-Mg basalts plot on their olivine control lines. So, their primary magmas were calculated by adding only equilibrium olivine. These samples are 9–25% fractionated, and their primary magmas were last equilibrated with garnet lherzolite at 25–36 kbar/1452–1531 °C. The estimated mantle potential temperatures are 1400–1500 °C for the Deccan tholeiites, consistent with their origin from a mantle plume.