Improved Heat Transfer Capabilities of Nanofluids—An Assessment Through CFD Analysis

Abstract Conventional fluids used in fission‐based water‐cooled nuclear reactors have lower heat transfer coefficients (HTCs) and thermal conductivity, which has led researchers to explore high‐performance fluids that can enhance heat transfer in routine operation and prevent core meltdown in the case of accidents. It is important to investigate a wide range of fluids that can help designers improve thermal hydraulic characteristics, such as HTC, critical heat flux, and minimum departure from nucleate boiling ratio (MDNBR). In this study, the effectiveness of nanofluids in enhancing heat transfer parameters, including thermal conductivity and heat capacity, was investigated. Four different nanofluids (Al 2 O 3 –H 2 O, ZrO 2 –H 2 O, Ag–H 2 O, and Si–H 2 O) with pure water as the primary coolant in an HPR‐1000 nuclear reactor were compared using computational methods. Due to computational limitations, only the flow channel among four fuel rods with the highest power density in the core was simulated using Eulerian computational fluid dynamics. The results of this study show that silver water (Ag–H 2 O) nanofluid outperformed other nanofluids and pure water. It had a higher average HTC and MDNBR, with a 67.15 % and 45.23 % improvement, respectively, compared to pure water. The fuel rod wall temperature was also reduced by 28.5 K with Ag–H 2 O compared to water. Comparison of current simulated results with literature data shows a good agreement.